|
The divider issue may be due to the fact that there are 2 kinds of dividers. One is a "pop in" kind that sort of just wedges in place. The other kind of divider has a slot routed in the back of the cage and screws from the top. They are both the same cost and virtually the same piece--it's how the cage is made to accept the divider that makes a slight difference. Sounds like you fixed it with some herpin' ingenuity!
I bugged Ali a lot when she was crankin' out the kid. She ended up calling me and going through all of the above with me (as well as heat tape vs. cable, etc...)--I don't think it's explained if you just buy it on the site.
I had been recommended AP cages by some serious local friends and have a couple of their racks. I've got (10) T6 cages that should ship this week....
|