Notices |
Hello!
Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.
Registration is FREE, so please register so you can participate instead of remaining a lurker....
Please note that the information requested during registration will be used to determine your legitimacy as a participant of this site. As such, any information you provide that is determined to be false, inaccurate, misleading, or highly suspicious will result in your registration being rejected. This is designed to try to discourage as much as possible those spammers and scammers that tend to plague sites of this nature, to the detriment of all the legitimate members trying to enjoy the features this site provides for them.
Of particular importance is the REQUIREMENT that you provide your REAL full name upon registering. Sorry, but this is not like other sites where anonymity is more the rule.
Also your TRUE location is important. If the location you enter in your profile field does not match the location of your registration IP address, then your registration will be rejected. As such, I strongly urge registrants to avoid using a VPN service to register, as they are often used by spammers and scammers, and as such will be blocked when discovered when auditing new registrations.
Sorry about all these hoops to jump through, but I am quite serious about blocking spammers and scammers at the gate on this site and am doing the very best that I can to that effect. Trust me, I would rather be doing more interesting things with my time, and wouldn't be making this effort if I didn't think it was worthwhile.
|
|
|
06-09-2016, 11:50 PM
|
#1
|
|
Outdoor bearded dragon cage
This is one of my many prototypes i have built. It measurers 8x4x1 and the front opens up for easy access, i am very happy with the results on this one.
|
|
|
06-09-2016, 11:52 PM
|
#2
|
|
Finshed picture sorry it is so dark i just finished it 30 minutes ago.
|
|
|
06-15-2016, 04:52 PM
|
#3
|
|
can you tell me about the cage? show it set up outside? i'm looking for options. currently, I have a HUGE parrot cage I've snakeproofed and filled with climbing branches, but my buddy can't run, which is what he most wants to do and can't in his 55 gal indoor habitat.
|
|
|
06-15-2016, 04:55 PM
|
#4
|
|
i think I'd have to wire top and bottom. either he'd tunnel out, or some dreadful Sonoran lizard eater would dig in! I often see him digging bi dubias out from under rocks and logs in his tank.
|
|
|
06-15-2016, 04:56 PM
|
#5
|
|
At freinds can tonight
|
|
|
06-16-2016, 03:02 PM
|
#6
|
|
What i did for the bottom was add 4 inches of gravel along the sides and a little extra on the corners and a 2 inch layer every were else but there burrow. Then i take sand and cover over all the gravel. The burrow i made a foot and a half deep by 2 feet wide, i them take a peice of plywood and put it on top of the burrow and cover the plywood with dirt to help insulate it, i also like the fact if i ever need to get them out i just have to lift the piece of plywood to get in the burrow. Supplys needed to build this enclosure is 1 sheet of 1/4 inch plywood (i recomend 1/2 inch),4 1x1 pieces of wood for the corners to make them stronger, a box of 3/4 inch screws, a roll of one inch or smaller poultry wire i used 2 feet wide (i recomend 3 feet) this is one of my 4 prototypes i have made and so far this seems to be there favorite. If you have anymore question you are free to contact me at 951-514-5210
|
|
|
06-16-2016, 03:37 PM
|
#7
|
|
Thank you so much!
|
|
|
06-16-2016, 03:44 PM
|
#8
|
|
Your welcome
|
|
|
06-16-2016, 04:10 PM
|
#9
|
|
Your boxes are clever and give dragons much more room than they would ever have in an aquarium type housing, and the overhang shield them from too much sun.
Have you ever thought of making these as a kit you could sell with everything pre cut?
Where is the door/entry?
|
|
|
06-16-2016, 04:15 PM
|
#10
|
|
The top opens up and i need to find a way to make the top more stable. I did think about making a kit but it would be when i get it perfected right now there all just prototypes and my dragons are loving the outdoors
|
|
|
Join
now to reply to this thread or open new ones
for your questions & comments! FaunaClassifieds.com
is the largest online community about Reptile
& Amphibians, Snakes, Lizards and number one
classifieds service with thousands of ads to look
for. Registration is open to everyone and FREE.
Click Here to Register!
|
Thread Tools |
|
Display Modes |
Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
Similar Threads
|
Thread |
Thread Starter |
Forum |
Replies |
Last Post |
[For Sale] Boa Master Bearded Dragon Cage
|
shocter |
Caging, Supplies & Services For Sale/Wanted |
1 |
03-26-2015 03:15 AM |
PVC Bearded Dragon cage
|
merox |
Bearded Dragons Discussion Forum |
1 |
07-28-2011 12:59 PM |
[Wanted] Bearded Dragon cage!
|
SilverBlaze |
Caging, Supplies & Services For Sale/Wanted |
9 |
09-13-2010 11:52 PM |
All times are GMT -4. The time now is 02:28 PM.
|
|