FaunaClassifieds - View Single Post - BAH-1000 question

08-14-2004, 09:49 AM

Hello again.

I have had my BAH-1000 hooked up now for about 5 days and it has been working OK. Currently I have the probe sitting on my tile almost on top of the hot spot generated by the UTH. Since I want the hot spot around 90-93 I set the BAH to around 90 since it is off the actual hot spot.

Through many days of trial and error I have realized I actually need to keep the temp setting around 83 or so in ordewre to keep my desired temps. Today however I woke up and my tile temp was 96+. I am thinking maybe due to the cold air temps the probe was not heating up, causing the UTH to remain on to heat it.

My point is the BAH has been just as much an issue as using a dimmer at this point. Has anyone else had trouble with this or can you give me any hints that will keep my temps stable with this thermostat?

08-14-2004, 09:49 AM	#1
AaronFromPA	BAH-1000 question Hello again. I have had my BAH-1000 hooked up now for about 5 days and it has been working OK. Currently I have the probe sitting on my tile almost on top of the hot spot generated by the UTH. Since I want the hot spot around 90-93 I set the BAH to around 90 since it is off the actual hot spot. Through many days of trial and error I have realized I actually need to keep the temp setting around 83 or so in ordewre to keep my desired temps. Today however I woke up and my tile temp was 96+. I am thinking maybe due to the cold air temps the probe was not heating up, causing the UTH to remain on to heat it. My point is the BAH has been just as much an issue as using a dimmer at this point. Has anyone else had trouble with this or can you give me any hints that will keep my temps stable with this thermostat?