I would pass on the soap. It is too easy to miss some and leave deadly suds in the water. The best things to use for cleaning aquariums are bleach or ammonia, NOT TOGETHER. Pick one, together they form a deadly gas. Why do I choose these?
Bleach = chlorine. Any traces of this will be removed with your water conditioner.
Ammonia is naturally occuring in fish tanks and is easily detected and removed via water changes. After cleaning, rinse, rinse and rinse some more, but just to make sure before adding fish, test for ammonia. Since you should already have an ammonia test kit anyways, it should be very quick and easy.
ALSO
As hhmore said above, ensure the tank is still well sealed.
If it is not, DO NOT just place a new coat of silicone over the existing. This is going to cause you a lot of regret as in the long run, it's not going to do you much good. INSTEAD, use a razor blade to remove the old silicone, clean the glass and apply a brand new seal. Be sure to check that the silicone you choose is aquarium safe, NOT ALL ARE! Let the silicone dry completely before filling with water. Then, even though it is supposedly safe, fill it up once and empty it before use just to make sure there are no chemicals left.
ALSO
as hadenglock mentioned let the filter run for a while before adding fish.
Ideally you should run the system including any heating or cooling for at least 48 before adding fish. This allows you to ensure there are no problems, but if there are, you can fix them BEFORE they cause any harm to your fish.
Good luck!
|