Here is a black anodized aluminum PC7 Plus with a dual 120mm fan configuration in great condition. The stock power switch has been replaced by a red sleeved and black heatshrinked red dot Bulgin switch. The stock reset switch is intact & included. The fan guard on the front fan bay was Dremeled out for better airflow. A 120mm blowhole was added on the top panel, but a deep power supply might be too close, so I added a hole and rubber grommet on the panel for a fan cord to fit through so a fan can be mounted externally if desired. A 120mm intake was added on the side panel over the video card area. Also included are two Panaflo L1A fans with UV blue sleeve and black heatshrink. One is in front as an intake and the other is the rear exhaust.
A 40mm hole was placed behind the 5.25" bays for easier cable management (I ran my ATX cable through this hole). I cut it too close to the 5.25" bays themselves, so I added duct tape to mask off the sharp cuts. This does not interfere with the use of any device in any of the bays. I also added thumbscrews to the PCI slot covers (the stock case uses regular screws). The rest of the case is stock (internal and external 3.5" drive bays, rubber case feet, etc.). All the needed screws (to secure drives, mobo standoffs and extras) are included too.
The front ports (USB, Firewire, Audio etc.), the speaker and the stock power & HDD LEDs are not included (the power LED is handled by the Bulgin switch). Extra case parts are available @ SilverPCs (
http://silverpcs.com).
I'm selling because I recently got a PC-A10B and have no use for this case anymore.
Asking $150 shipped (UPS or USPS).
I accept Paypal (credit or bank accounts).
Refs: 148+ eBay feedback and 10+ Heat under Sparkpug.
Pics:
http://home.comcast.net/~sparkpug/PC7_01.JPG
http://home.comcast.net/~sparkpug/PC7_02.JPG
http://home.comcast.net/~sparkpug/PC7_03.JPG
http://home.comcast.net/~sparkpug/PC7_04.JPG
http://home.comcast.net/~sparkpug/PC7_05.JPG
http://home.comcast.net/~sparkpug/PC7_06.JPG