| Notices |
Hello!
Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.
Registration is FREE, so please register so you can participate instead of remaining a lurker....
Please note that the information requested during registration will be used to determine your legitimacy as a participant of this site. As such, any information you provide that is determined to be false, inaccurate, misleading, or highly suspicious will result in your registration being rejected. This is designed to try to discourage as much as possible those spammers and scammers that tend to plague sites of this nature, to the detriment of all the legitimate members trying to enjoy the features this site provides for them.
Of particular importance is the REQUIREMENT that you provide your REAL full name upon registering. Sorry, but this is not like other sites where anonymity is more the rule.
Also your TRUE location is important. If the location you enter in your profile field does not match the location of your registration IP address, then your registration will be rejected. As such, I strongly urge registrants to avoid using a VPN service to register, as they are often used by spammers and scammers, and as such will be blocked when discovered when auditing new registrations.
Sorry about all these hoops to jump through, but I am quite serious about blocking spammers and scammers at the gate on this site and am doing the very best that I can to that effect. Trust me, I would rather be doing more interesting things with my time, and wouldn't be making this effort if I didn't think it was worthwhile.
|
 |
08-23-2010, 08:47 PM
|
#1
|
|
|
Temp Question
I have a stupid question. Ive been using Acurite thermometers in my rack to measure my temps. I just purchased a raytek infared thermoter for a more accurate way to measure different spots in the tub. Well my Accurite have been showing a hotspot of 89 to 92. When i checked it with my raytek it is only showing a hotspot of about 86 to 88. Is the temp difference because my probe on my Accurite is directly touching the tub or are they not that accurate?
|
|
|
|
|
08-23-2010, 09:02 PM
|
#2
|
|
|
I would say accuracy is the problem. Point the Raytek at the same spot and check the temp. several times, it will vary a degree or so. After you have used it for a while they are good for checking that things are working ok (heat tape plugged in etc..) but I would not rely on them being 100% correct. Good luck!
|
|
|
|
Join
now to reply to this thread or open new ones
for your questions & comments! FaunaClassifieds.com
is the largest online community about Reptile
& Amphibians, Snakes, Lizards and number one
classifieds service with thousands of ads to look
for. Registration is open to everyone and FREE.
Click Here to Register!
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT -4. The time now is 02:36 PM.
|
|
Linear Mode
