• In the past two days I have gotten emails asking about being requested to provide credit card info in order to register and also to make a post in the classifieds forums. PLEASE NOTE: In no instance will this site ask you for this sort of information. The only time any request for payment is made is if you choose to opt-in for a higher membership level, and that is done SOLELY through PayPal. Anything else is coming from a source other than this site. My guess is that this is coming through Google Adsense, but when I can get someone to send me a screen shot of this sort of request, I will know more.
  • Responding to email notices you receive.
    **************************************************
    In short, DON'T! Email notices are to ONLY alert you of a reply to your private message or your ad on this site. Replying to the email just wastes your time as it goes NOWHERE, and probably pisses off the person you thought you replied to when they think you just ignored them. So instead of complaining to me about your messages not being replied to from this site via email, please READ that email notice that plainly states what you need to do in order to reply to who you are trying to converse with.

Alternate methods for heating a rack

Herpin Man

Herpin Man

Contributing Member
Contributor
Joined
Jul 28, 2016
Messages
405
Reaction score
95
Points
28
Location
Red Wing MN
I have a rack system that I am having a difficult time heating. I have heat tape, but am having a difficult time creating a warm enough hot spot through even a thin layer of coco substrate.
Does anybody have any suggestions for creating a basking spot? The tubs are deep enough to accommodate a light fixture, although I am hesitant to attach electrical fixtures directly to a plastic tub.
Any ideas?
 
Have you insulated the rack? I try to wrap my racks in insulation since it will help hold the heat in. Also what do you have the hot spot set to?
 
No it is not insulated. It is a standard rack with PVC shelves heat tape on the shelves, boards on the side to hold it together. The room is heated, though. Ambient heat is ok, I just need a hot spot. Thermostat is set to 100, having a hard time getting the hot spot much above 80.
 
Are the tubs curved so that there is a large air gap between the floor of the tub and the heat tape? If so have you tried putting a book in the tub on the hot spot to simulate the weight of the snake, and then take the temperature a while later?
 
The tubs are sterilite, and have a slight rib on the edges. However I do not have this problem with newspaper; coco fiber is apparently not very conductive.
Do you have any ideas for installing a safe heat lamp?
 
Herpin Man said:
Do you have any ideas for installing a safe heat lamp?
Click to expand...
I don't and I don't think a heat lamp is a good option as the plastic starts to melt at a fairly low temperature compared to the temperature of the heat lamp housing.

I think you'd be better off going back to paper substrate over the heat tape area, and you could use coco fiber on the cool side. That's what I do in the winter to keep humidity up - my house gets very dry - except I use cypress mulch not coco fiber on the cool side of the tub.
 
I've had this problem before, I was just forced to go back to paper towels. You can try not covering the side where the heat tape is under. Or just use coco fiber during the summer, if it gets hot enough in your area. I know everything I said was kinda just went over but I had to point out I have the same problem with my bigger belly heat (holdback) racks, not really the same issue with my hatchling back heat rack.
 
Back
Top