• Responding to email notices you receive.
    **************************************************
    In short, DON'T! Email notices are to ONLY alert you of a reply to your private message or your ad on this site. Replying to the email just wastes your time as it goes NOWHERE, and probably pisses off the person you thought you replied to when they think you just ignored them. So instead of complaining to me about your messages not being replied to from this site via email, please READ that email notice that plainly states what you need to do in order to reply to who you are trying to converse with.

  • IMPORTANT! PLEASE READ!! About the Google Adsense ads being displayed

    =====================
    Posted 08/15/2025
    =====================


    Yeah, I know. They are a pain in the butt. But they pay the bills to keep my server running. Just a fact of life, I am afraid.

    Want to get rid of them? Simple. Just become a Contributor level member or above and they will be gone. -> Please click HERE."

    Is that too much for me to ask of you to keep this site running? Well, sorry about that. I too wish I could get everything for free. But alas.....

    =====================
    Addendum: 01/10/2026
    =====================


    Google Adsense ad revenue for December, 2025 was just $30 over the cost of the lease for the server running this site. So, in effect, the money providing the incentive for me to continue running this site is coming SOLELY from the paid memberships and sponsorships here. Which honestly ain't much....

More Heat Questions

F

Flatfish1

Member
Joined
May 29, 2019
Messages
85
Reaction score
1
Points
8
Location
Julian, CA
When a care guide suggests a hot side temperature of, say 90 degrees, with an under tank heater, Am I correct in assuming they are referring to the surface temperature of the enclosure floor and not the temperature of the air?

If so, Should I measure the temp (with a temp gun) on the surface of the substrate? Or, should I dig down and measure the temp on the surface of the actual floor of the enclosure? In other words, If a loose substrate like sanichips is used, the snake could burrow through the substrate and contact the actual floor. Don't want anybody getting burned! For example, when I measure the temp on the top of my substrate (over the heat pad), It reads about 80 to 82 degrees. When I move the substrate to the side and read the actual glass surface of the enclosure floor, It reads between 92 to 95 degrees. Quite a difference. By the way, the substrate is about 1" thick.

So, if I'm aiming for 90 degrees, Am I close enough with the above example?

And one last question: when I read a temp of about 95 degrees on the surface of the enclosure bottom (no substrate in the way) and the bottom is clear glass (Exo-Terra terrarium), Is that an accurate reading? When I feel the surface of the glass with my hand, it just doesn't feel like 95 degrees to me. So is my temp gun laser shooting through the clear glass and reading the actual top surface of the under tank heater? Meaning the actual glass floor surface is a bit cooler than the actual temp reading I'm getting.

I know I ask a lot of verbose questions! Sorry. I like to get to the bottom of things!

Wayne
 
Yes typically when a care sheet specifies a 90*F hot spot or basking spot, that is the surface temperature of the glass over top off the under-tank heater. To achieve this you want to sandwich the thermostat probe between the heat pad and the underside of the enclosure. Typically if you set the thermostat to 91-92*F you'll get a surface temp of 90*F. Using the temperature gun or IR thermometer to take the reading is fine.
 
Back
Top