• In the past two days I have gotten emails asking about being requested to provide credit card info in order to register and also to make a post in the classifieds forums. PLEASE NOTE: In no instance will this site ask you for this sort of information. The only time any request for payment is made is if you choose to opt-in for a higher membership level, and that is done SOLELY through PayPal. Anything else is coming from a source other than this site. My guess is that this is coming through Google Adsense, but when I can get someone to send me a screen shot of this sort of request, I will know more.
  • Responding to email notices you receive.
    **************************************************
    In short, DON'T! Email notices are to ONLY alert you of a reply to your private message or your ad on this site. Replying to the email just wastes your time as it goes NOWHERE, and probably pisses off the person you thought you replied to when they think you just ignored them. So instead of complaining to me about your messages not being replied to from this site via email, please READ that email notice that plainly states what you need to do in order to reply to who you are trying to converse with.

putting holes in sterilite tubs

C

Copperhead1121

Member
Joined
Jul 16, 2014
Messages
81
Reaction score
1
Points
8
Location
Goodwater, AL
I'm not sure i should ask this is this section so i'm sorry if that's the case. I was in the process of moving from aquariums into sterilite tubs and will be using the tops on them when in the rack. I was wondering if putting the holes in the top is as effective as putting them in the sides. I really personally don't like the look of the holes in the side but will ventilation still be good if done in the tops? Thanks for any responses.
 
If the rack is of standard construction, meaning a relatively snug fit, then ventilation is likely not going to be as effective on the tops as it would be on the sides, simply because there isn't as much airspace.
If you decide to drill the sides of your boxes I'd like to share this little nugget that has worked well for me in the past. To prevent the plastic from cracking when drilling, simply back up each mark with a block of wood before drilling making sure to hold it firmly against the plastic. If you don't have a piece of wood handy, then an old book will work just as well.
Best of luck with your new set ups!
 
Yes if there isnt much room between shelves to allow air flow i would definetly put a few in the sides. This will help allow a cross wind & air will actually exchange. You can always put the holes up high so there not as noticeable. Good luck
Chris
B and S Pythons/facebook
 
Back
Top