• In the past two days I have gotten emails asking about being requested to provide credit card info in order to register and also to make a post in the classifieds forums. PLEASE NOTE: In no instance will this site ask you for this sort of information. The only time any request for payment is made is if you choose to opt-in for a higher membership level, and that is done SOLELY through PayPal. Anything else is coming from a source other than this site. My guess is that this is coming through Google Adsense, but when I can get someone to send me a screen shot of this sort of request, I will know more.
  • Responding to email notices you receive.
    **************************************************
    In short, DON'T! Email notices are to ONLY alert you of a reply to your private message or your ad on this site. Replying to the email just wastes your time as it goes NOWHERE, and probably pisses off the person you thought you replied to when they think you just ignored them. So instead of complaining to me about your messages not being replied to from this site via email, please READ that email notice that plainly states what you need to do in order to reply to who you are trying to converse with.

RBI CS3020-5 28 Qt snake rack - Heat Tape Faces Down?

K

Kipling

New member
Joined
Apr 16, 2014
Messages
6
Reaction score
0
Points
0
Location
Reno, NV
Hello! I'm assembling my first snake rack and have a small issue with the heat tape portion and if anyone out there has this rack (or something like it) and can guide me here I'd appreciate it.

Okay so I assembled my rack (A CS3020-5 28 Qt snake rack from Reptile Basics) and my heat tape came prewired (which is awesome). I threaded the heat tape (facing UP) in through the first shelf as the instructions tell you, and then it goes on to say in the instruction book:
"Next feed the free end of the heat tape back onto the same slot that it exits, down through the opening between the shelf and side and out through the opening on the level below. (Fig 6) Holding the heat tape at as shown, (fig 7) pull out the excess until completely inside the rack. Repeat this for each shelf."

Does this mean that the heat tape faces DOWN on the next shelf? The photos really don't make it clear. Will it heat properly if the tape faces down? Will it melt the plastic? I don't want to mess this up, any help would be appreciated. Thank you!
 
And by 'facing down' I mean the copper strips face down, into the plastic, as opposed to the copper strips facing 'up' into the air. Should have made that clear. Thanks!
 
It's fine to route heat tape that way, it's fairly common in racks.
There is no top or bottom to heat tape, it heats the same regardless of which side is up.
 
Back
Top