• In case most of you have not noticed, I made changes to the donation amounts as well as the durations for all of the paid membership levels. Things are winding down here, and this seems to be the most prudent way to deal with the "end of life" period of this site.

    Contributor level members - $10 per 30 days
    Sponsors - Eliminated
    Benefactor level members - $25 per 30 days
    Endowment level members - $50 per 30 days

    Account Upgrades Page
  • Responding to email notices you receive.
    **************************************************
    In short, DON'T! Email notices are to ONLY alert you of a reply to your private message or your ad on this site. Replying to the email just wastes your time as it goes NOWHERE, and probably pisses off the person you thought you replied to when they think you just ignored them. So instead of complaining to me about your messages not being replied to from this site via email, please READ that email notice that plainly states what you need to do in order to reply to who you are trying to converse with.

Swapping out heater controls???

Goombas Reptiles

Goombas Reptiles

New member
Joined
Nov 6, 2009
Messages
90
Reaction score
1
Points
0
Location
Philly, PA
I'm working on a mini fridge incubator and I was curious if swapping out the heating element from a hovabator and putting it in the fridge will actually work? All that holds it to the top of the hovabator is a few small bolts. It would be super easy to mount it to the top of the fridge. I dont have to change anything, not even the wiring. Any ideas? Eventually I'm going to get a real thermostat setup but I'm on budget right now and the hovabator is not big enough for the expected bp clutches soon to be coming. I appreciate the input.
 
Well, given my opinion of Hovabators (especially for snake eggs), the easy answer is "don't bother". However, if you are of a mind to do it, go for it. The heating unit is easy enough to transfer...I'm not so sure that the controller will be as simple, at least not without some reconfiguration (It's been a long time since I even looked at a hovabator). Depending on the thickness of the top, you may be able to just drill a hole for the adjusting mechanism, and keep the control on the outside; but you'll probably have to either replace it (the "screw" probably won't be long enough), or mount the whole thing inside. Having to open the incubator to adjust the temps seems counterproductive to me, though.
 
I agree with Harold.

I have a small fridge I converted for an incubator but I am using a helix thermostat, flexwatt heat tape, and a cpu fan.

At least mount the heating element on the bottom where it will allow heat to rise but you really need a fan to circulate it.
 
Back
Top